Exhibitors @ NAB, IBC, IBTS

Tally Matrix Front Panel

Rear Panel

MTX-ENC 200 is a Tally Matrix system that direct interfaces with many Routers (e.g. Sony, Leitch, Utah, Thomson Grass Valley, Quartz, Sandar etc). Tally X-points are identificated from the router by a RS232 connection so to operate tallies following the internal configuration system. There are two different working maps, the first one follows the router, the second one is assigned by the MTX-PC software. It is also possible to force the entire map to a pre-assigned status configured by a PC.

It is possible to work interfacing the router or in stand-alone with file Salvo.
The system operates without a PC, which is necessary only to configure the system itself.
MTX-ENC 200 is a modular system that can manage until 512 different X-points wired in RS485. Configuration and status are stored in an internal memory. In the event of Power failure the system will not loose any X-point or setting.

220VAC or 110VAC Power Supply with low power consumption (10VA).
 
 

Technical Data

INPUT AND OUTPUTS modules 32 pull-to-ground Inputs 32 contact-closure-to-ground Outputs

POWER SOURCE Mains Ranges Voltages 220VAC Frequency 50÷60Hz Power Consumption 10VA

TEMPERATURE RANGE Operating  0÷50°C

PHYSICAL CHARACTERISTICS Height  44mm (1.75") Width  482mm (19") Depth  115mm (4.5")

 

MATRIX DIMENSION 32 X 32 EXPANDIBLE IN SIMILAR BLOCKS up to 512 X 512 IN OUT

Software map: